Forum: NGINX Use pcre-config to set ngx_feature_path and ngx_feature_libs

Hi, there.

Here is a patch for using  pcre-config to set ngx_feature_path and
ngx_feature_libs.
I need this since I would like to use pcre 8.32 built from source and
installed in /opt/lib64/libpcre.so.1.

Could you review this patch?
Thanks

Hello!

On Thu, Jan 10, 2013 at 12:48:38AM +0900, Hiroaki Nakamura wrote:

> --
> )Hiroaki Nakamura) hnakamur@gmail.com

> +            ngx_feature_libs="`pcre-config --libs`"
> +
> +            . auto/feature
> +        fi
> +
> +        if [ $ngx_found = no ]; then
> +
>              # FreeBSD port
>
>              ngx_feature="PCRE library in /usr/local/"

I don't think that "`pcre-config --prefix`/include" is a good
aproach.

Have you considered just using

./configure --with-cc-opt="-I/path/to/include" 
--with-ld-opt="-L/path/to/lib" ...

?

--
Maxim Dounin
http://nginx.com/support.html

Hi!

In my case
./configure --with-pcre-jit --with-cc-opt="-I/opt/include"
--with-ld-opt="-L/opt/lib64 -lpcre"
does it!

Now it is properly configured without my patch. I get the following 
output.

Configuration summary
  + using system PCRE library

Thank you very much for your help.

2013/1/10 Maxim Dounin <mdounin@mdounin.ru>:
>>
>>          if [ $ngx_found = no ]; then
>> +        if [ $ngx_found = no ]; then
> ./configure --with-cc-opt="-I/path/to/include" --with-ld-opt="-L/path/to/lib" 
...
> http://mailman.nginx.org/mailman/listinfo/nginx
--
)Hiroaki Nakamura) hnakamur@gmail.com