Forum: GNU Radio New block for GRC on USRP E110 isn't available

Hi! I'm working with a USRP E110 and I made a new block for GRC 3.6.2 
using gr_modtool.
The block was generated and put in system using cmake, make and make 
install commands without errors, but this not available in any category 
in GRC.
Anyone knows if gr_modtool is right to make blocks for GRC 3.6.2 on E110 
or that should be done differently?

Best regards.

AA

On Wed, Dec 05, 2012 at 08:43:59PM +0000, Adriana Arteaga wrote:
> Hi! I'm working with a USRP E110 and I made a new block for GRC 3.6.2 using
> gr_modtool.
> The block was generated and put in system using cmake, make and make install
> commands without errors, but this not available in any category in GRC.
> Anyone knows if gr_modtool is right to make blocks for GRC 3.6.2 on E110 or
> that should be done differently?

Are you sure your XML works? GRC is *very* picky with the files, and
the output of 'gr_modtool.py makexml' is usually not correct (but better
than nothing for editing yourself).

Open gnuradio-companion in the console and see if throws any errors.

The category, if you don't change that, is the same as your module name
(e.g. gr-howto -> HOWTO).

M

>
> Best regards.
>
> AA
>
>
>

> _______________________________________________
> Discuss-gnuradio mailing list
> Discuss-gnuradio@gnu.org
> https://lists.gnu.org/mailman/listinfo/discuss-gnuradio


--
Karlsruhe Institute of Technology (KIT)
Communications Engineering Lab (CEL)

Dipl.-Ing. Martin Braun
Research Associate

Kaiserstraße 12
Building 05.01
76131 Karlsruhe

Phone: +49 721 608-43790
Fax: +49 721 608-46071
www.cel.kit.edu

KIT -- University of the State of Baden-Württemberg and
National Laboratory of the Helmholtz Association