Forum: GNU Radio Re: daughterboard xcvr2450 tx/rx

Announcement (2017-05-07): www.ruby-forum.com is now read-only since I unfortunately do not have the time to support and maintain the forum any more. Please see rubyonrails.org/community and ruby-lang.org/en/community for other Rails- und Ruby-related community platforms.
Valerio, Danilo (Guest)
on 2009-03-03 11:26
(Received via mailing list)
Same problem here!
I am running gnuradio from trunk (rev. 10496), on kubuntu 8.10.
I have a USRP2, firmware and FPGA updated to the last available version.
I am also a very beginner.
If I set any frequency other than 2.4GHz (by just modifying it in the
grc block) I get a choppy, blinking, and buggy signal.

There are so few examples on the USRP2 in the code and it is not so easy
to understand how to work with it if you have never used a USRP1.

Best Regards,
Dan
This topic is locked and can not be replied to.