Forum: GNU Radio RFX1200 RX Tuning problem

Announcement (2017-05-07): www.ruby-forum.com is now read-only since I unfortunately do not have the time to support and maintain the forum any more. Please see rubyonrails.org/community and ruby-lang.org/en/community for other Rails- und Ruby-related community platforms.
Pascal (Guest)
on 2009-02-01 21:29
(Received via mailing list)
I have an new USRP (sn3361 tested on 12-Mar-2008) and a RFX1200 (which
in fact is a factory modified RFX2400 board) which I bought about two
years ago but only until now I'm playing with.

It is recognized as Flex 1200 Tx MIMO B (and of course Flex 1200 Rx MIMO
B) and the frequency range is  (1150000000.0, 1350000000.0, 4000000.0).

Oddly enough there is no 0 Ohms resistor at position R84 and R115.

The board transmits nicely on 1296 MHz no problems there.
However it does not tune anny frequency on the receiver site.
Even usrp_fft.py -R B tells me that tuning failed.

I've tried about everything I could figure but no result

by the way on side A there is an antique RFX400 Board with on board
64MHz clocks, this board is doing fine.

Annyone an idea what could be wrong with the RX PLL while the TX PLL is
ok ?

Pascal
This topic is locked and can not be replied to.